ONGAA CAM for HOMAG/BIESSE/HOLZHER

OVERVIEW

With ONGAA CAM drilling processes can be defined in a wide variety of ways.  This section will cover all available drill process selection options.

SINGLE EDGE

To define a single drill hole simply the the upper edge of the hole.  ONGAA CAM will use the edge to define the X & Y location and the diameter for the dill process.  In addition, ONGAA CAM will  search for the bottom of the cylinder.

Once the edge is selected, both Speed and Feed Mode can be selected as in WoodWOP.

Using the single edge selection method, ONGAA CAM will always default to ‘Drill to depth mode’.  If ‘Drill through is required it can be set in the additional options section.

TWO EDGES

When a drill hole is intersected by another machining operation, ONGAA CAM would … Read the rest

Making ONGAA CAM easier to use and save even more of your valuable time has been the focus of the design team over the past few months and it has paid off. ONGAA CAM now provides an even easier and faster way to add machining to models.

• Drill all vertical holes on a FACE with a single ONGAA CAM process.
• Create all vertical pockets on a FACE or SKETCH with a single ONGAA CAM process.
• Create all polygon pockets on a SKETCH with a single ONGAA CAM process.

Vertical drills and Vertical pockets both provide Min/Max criteria to allow smart WoodWOP process creation when using faces as the source of the geometry. Simply select the FACE, click All Holes and ONGAA CAM generates a vertical drill process in WoodWOP for each hole that meets the min/max criteria. As with all ONGAA CAM processes, the ‘instructions’ to expand a face